8 Item Items
Waarschuwing: laatste item(s) op voorraad!
3D Printer Controller For RAMPS 1.4 Reprap Mendel Prusa Support Arduino Boards
Fully assembled & tested, no soldering required
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost
The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion
A number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack
Size: Approx. 11.5 x 6 cm / 4.53 x 2.36 inch
1 x 3D printer controller for RAMPS 1.4
Geen klantenbeoordelingen op het moment.