10 Item Items
Waarschuwing: laatste item(s) op voorraad!
MKS Gen V1.1 3D Printer Control Motherboard Compatible RepRap Ramps1.4 With USB Cable
It gather 2560 and ramps1.4 on a same board, which solved the Ramps1.4 combination interface problem, which easily out of order
Can replace the motor driver, support 4988 drivers and 8825 drivers
Circuit board uses the high quality of 4 layer board,optimize heat dissipation;Ramp Is 2 layer board
Using special power supply chip, support the 12v-24v power input, solve the problem of Ramps voltage conversion of chip fever
Can accept 24 v input, under the same system power can reduce the current hot bed to 1/4, effectively solve the problem of hot bed MOS tube heating
The firmware can use open source firmware Marlin, configuration are exactly the same with ramps1.4 , can be directly replace ramps1.4 also
Can be connected directly to Ramps1.4, 2004 LCD control board and the LCD board (12864)
Provide three 5V output, three 12V-24V output interface
If the power supply is wrong connection, motor driver board is likely to be burned chip and circuit, please confirm again after repeatedly for electricity
1 x MGK Gen V1.1 Motherboard
1 x USB cable
Geen klantenbeoordelingen op het moment.